Rev1/2015 1 | P a g e By Galaxy Series Installation & Operations Manual Note: You must read all installation & operat
Rev1/2015 10 | P a g e Turn on the water and test. Of the unit still leaks, replace the cartridge (E). Make sure that both hot and cold water inl
Rev1/2015 11 | P a g e CONTROL PARTS INFORMATION FOR STEAM SHOWER FOR ALL UNITS 1. Steam Temperature Sensor 2. LCD Display 3. Control Panel 4.
Rev1/2015 12 | P a g e CONTROL PANEL FOR STEAM SHOWER: CONTROL PROCEDURES Power on/off Push any button to light the display, and press the powe
Rev1/2015 13 | P a g e Chromatherapy This button controls the color of the Chromatherapy LED lights (picture 5). When the Chromatherapy function sta
Rev1/2015 14 | P a g e WIRELESS FM TRANSMITTER On/Off: Push and hold this button for power on/off. Push and release this button shortly to change
Rev1/2015 15 | P a g e TROUBLESHOOTING FOR STEAM CABIN ISSUE CAUSE SOLUTION Touch panel does not work 1. Not connected properly Check connection bet
Rev1/2015 16 | P a g e
Rev1/2015 2 | P a g e Table of Contents Tools Needed for Installation ……………………………………………. 3 Product Features ……………………………………………. 3 Unit Information ……
Rev1/2015 3 | P a g e TOOLS REQUIRED FOR INSTALLATION: Level Screw driver #2 Phillips Silicone Wrench Electric Drill Square Ruler Rubber mallet PR
Rev1/2015 4 | P a g e ELECTRICAL INFORMATION 1 dedicated 12-2 wire with 20 amp GFCI breaker (220V) Connect the overhead light, speaker, fan, CD
Rev1/2015 5 | P a g e BASE OPTIONS The standard WS-112 shower enclosure does not include a base. It can be installed over a custom or existing base o
Rev1/2015 6 | P a g e INSTALLATION INSTRUCTIONS FOR WS112 ALL SIZES 1. The distance between Wall A and Wall B should be at least 1510mm (59.5 inches
Rev1/2015 7 | P a g e Note: Panel with hinge holes goes on the left side. Install the front fixed glass panels. Remove plastic clip in horizontal f
Rev1/2015 8 | P a g e INSTALL THE GASKETS 1. Once all is connected, place the wooden shower grid floors and benches inside the unit. 2. Please, d
Rev1/2015 9 | P a g e TEMPERATURE ADJUSTMENTS Adjustment gear (A) is factory-set to prevent stem from reaching full hot position. To adjust stem r
Kommentare zu diesen Handbüchern